feedback
facebook page
Follow Me on Pinterest
twitter page
google plus page
rss feed

Recalled Product

List of recalls for Crane COE

Search Recalls or Browse by Category
Consumer Products (?)
Food & Health (?)
Vehicles (?)

Crane COE Recalls

There have been 2 recalls on COE vehicles in recent years. The latest, dated 2015-05-27 and published by the NHTSA on 2015-06-27, was due to a problem with the engine. Approximately 630 vehicles were involved. Since 1996, COE's have experienced approximately 7 recall(s) due to hazards with various components, including the vehicle speed control, labels. See a list of recalls for your model year below.

IMPORTANT NOTE: Also check the list of Additional Crane Models to the right. At times, the manufacturer or the NHTSA may use slightly different model names, or group models together by series.

Recalled Crane COE vehicles

Do you work for Crane? Contact us to learn how you can control data, information and ads shown on this page.

Detailed Recall Information for Crane COE

Show Recalls for Model Year:
All
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2015-05-27 (Published by NHTSA on 2015-06-27)
Recall Summary: Crane Carrier Company (Crane Carrier) is recalling certain model year 2008-2015 COE, LDT2, and LET2 trucks manufactured February 25, 2008, to May 20, 2015, and equipped with certain Cummins Westport ISL G engines. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.
Hazard: If engine oil comes into contact with a hot surface, there is an increased risk of a fire.
Remedy: Cummins will notify owners on behalf of Crane Carrier, and dealers will secure the ends of the 90-degree elbow. In addition, the electronic control module (ECM) will be reprogrammed with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 12, 2015. Owners may contact Crane Carrier customer service at 1-918-836-1651 or Cummins customer service at 1-800-343-7357.
Additional Info: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
NHTSA Source: http://www-odi.nhtsa.dot.gov/recalls/recallresults.cfm?start=1&SearchType=QuickSearch&rcl_ID=15V314000
   
2014-03-19 (Published by NHTSA on 2014-04-08)
Recall Summary: Crane Carrier Company (Crane) is recalling certain model year 2008-2014 LET2, COE, LDT2, and LE2 refuse vehicles manufactured April 16, 2008, through February 28, 2014, and equipped with certain Cummins Westport Model ISL G engines. Condensation in the intake manifold may freeze during cold weather conditions and interfere with the proper operation of the intake manifold pressure sensor.
Hazard: The improper operation of the sensor could induce elevated exhaust temperatures or flames from the exhaust pipe, increasing the risk of a vehicle fire or burn injury to a person near the exhaust pipe.
Remedy: Cummins Inc. and Cummins Wesport Inc. will notify owners, and authorized Cummins service facilities will upload a new ECM calibration, free of charge. The manufacturer has not yet provided a notification schedule. Customers may contact contact Crane at 1-918-832-7305 or Cummins Inc. at 1-800-343-7357.
Additional Info: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
NHTSA Source: http://www-odi.nhtsa.dot.gov/recalls/recallresults.cfm?start=1&SearchType=QuickSearch&rcl_ID=14V124000
   
2008-02-01 (Published by NHTSA on 2008-02-01)
Recall Summary: CRANE CARRIER IS RECALLING 672 MY 1999-2001 COE,MY 1999-2002 LDT, MY 2001-2007 LDT2, MY 1998-2003 LET, AND MY 2001-2007 LET2 REFUSE CAB AND CHASSIS FOR FAILING TO COMPLY WITH THE BRAKE RELEASE TIMING REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS." THE BRAKE RELEASE TIMING WAS SLOWER THAN REQUIRED.
Hazard: THIS STANDARD SPECIFIES PERFORMANCE AND EQUIPMENT REQUIREMENTS FOR VEHICLES EQUIPPED WITH AIR BRAKE SYSTEMS, INCLUDING AIR-OVER-HYDRAULIC BRAKE SYSTEMS, TO ENSURE SAFE BRAKING PERFORMANCE UNDER NORMAL AND EMERGENCY CONDITIONS.
Remedy: CRANE WILL REPLACE SEVERAL FITTINGS AND HOSES WHICH WILL INCREASE THE AIR FLOW AND SUBSEQUENTLY IMPROVE THE BRAKE RELEASE TIMING. THE RECALL BEGAN ON MARCH 14, 2008. OWNERS MAY CONTACT CRANE CARRIER AT 918-832-7305.
Additional Info: CUSTOMERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV.
NHTSA Source: http://www-odi.nhtsa.dot.gov/recalls/recallresults.cfm?start=1&SearchType=QuickSearch&rcl_ID=08V049000
   
2004-07-21 (Published by NHTSA on 2004-07-21)
Recall Summary: CERTAIN TRUCKS EQUIPPED WITH NEXGEN LIQUID NATURAL GAS (LNG) TANKS ARE BEING RECALLED. THE INTRODUCTION OF WATER INTO THE DISCHARGE SIDE OF BOTH THE PRIMARY AND SECONDARY RELIEF VALVES SIMULTANEOUSLY AND SUBSEQUENT FREEZING IN SERVICE CAN RENDER THE VALVES TEMPORARILY INOPERATIVE.
Hazard: IF NOT INSPECTED THE RISK OF TANK OVER-PRESSURIZATION AND A CATASTROPHIC TANK RUPTURE CAN OCCUR, POTENTIALLY RESULTING IN SERIOUS INJURY OR DEATH.
Remedy: CRANE WILL PERFORM AN INSPECTION AND PROVIDE INSTRUCTIONS FOR ORDERING AND INSTALLING THE RETROFIT KIT. THE RECALL IS EXPECTED TO BEGIN DURING JULY 2004. OWNERS SHOULD CONTACT CRANE AT 918-832-7305.
Additional Info: CUSTOMERS CAN ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
NHTSA Source: http://www-odi.nhtsa.dot.gov/recalls/recallresults.cfm?start=1&SearchType=QuickSearch&rcl_ID=04V339000
   
2003-07-17 (Published by NHTSA on 2003-07-17)
Recall Summary: ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH CUMMINS C8.3G AND L10G ELECTRONIC CONTROL MODULES (ECM), THE ECM DOES NOT HAVE THE ABILITY TO DETECT A THROTTLE FAIL-SAFE ENGINE SHUTDOWN COMMAND. THIS COULD RESULT IN AN UNANTICIPATED, UNCOMMANDED OPEN THROTTLE CONDITION WITHOUT WARNING.
Hazard: IF THIS EVENT OCCURS, THE VEHICLE OPERATOR WILL NOT HAVE CONTROL OF THE ENGINE SPEED, POSSIBLY RESULTING IN A VEHICLE CRASH.
Remedy: CUMMINS WILL NOTIFY THE CUSTOMERS AND REPLACE THE ECM. OWNERS SHOULD CONTACT CUMMINS AT 1-800-343-7357 OR CRANE CARRIER AT 1-918-836-1651.
Additional Info: CUSTOMERS CAN ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
NHTSA Source: http://www-odi.nhtsa.dot.gov/recalls/recallresults.cfm?start=1&SearchType=QuickSearch&rcl_ID=03V244000
   
2003-06-09 (Published by NHTSA on 2003-06-09)
Recall Summary: ON CERTAIN TRAILERS EQUIPPED WITH A SPECIFIC COMBINATION OF REYCO SUSPENSION, EATON DRIVE AXLE, AND BENDIX SLACK ADJUSTERS, THE FAILURE OF A DRIVE AXLE SLACK ADJUSTER TO AUTOMATICALLY ADJUST AS REQUIRED TO COMPENSATE FOR BRAKE WEAR, WILL CAUSE AN OUT OF ADJUSTMENT CONDITION. IF THIS CONDITION OCCURS AND IS NOT IDENTIFIED AND CORRECTED THROUGH NORMAL INSPECTIONS AND MAINTENANCE, THE SLACK ADJUSTER WILL OVER-ROTATE AND MAY CONTACT THE SUSPENSION LOWER SPRING SADDLE.
Hazard: IF THIS OCCURS, BRAKING PERFORMANCE WILL BE INHIBITED, INCREASING THE RISK OF A CRASH WITHOUT WARNING.
Remedy: CRANE CARRIER WILL SUPPLY, AT NO CHARGE, GUNITE SLACK ADJUSTERS AND INSTALLATION INSTRUCTIONS TO REPLACE THE EXISTING BENDIX SLACK ADJUSTERS ON THE DRIVE AXLE. THE INSTALLING FACILITY WILL BE REIMBURSED BY CRANE FOR ONE (1) HOUR LABOR PER VEHICLE AT THEIR POSTED LABOR RATE. OWNER NOTIFICATION BEGAN ON JUNE 10, 2003. OWNERS SHOULD CONTACT CRANE AT 1-918-832-7305.
Additional Info: CUSTOMERS CAN ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
NHTSA Source: http://www-odi.nhtsa.dot.gov/recalls/recallresults.cfm?start=1&SearchType=QuickSearch&rcl_ID=03V167000
   
2002-09-05 (Published by NHTSA on 2002-09-05)
Recall Summary: ON CERTAIN TAG AND PUSHER AXLE ASSEMBLIES PURCHASED FROM RIDEWELL, THE AXLE ASSEMBLIES HAVE AN ACTUAL WEIGHT RATING LESS THAN THAT SPECIFIED ON THE LABEL AND THEREFORE FAIL TO COMPLY WITH THE REQUIREMENTS OF PART 567.5, "CERTIFICATION."
Hazard: LOADING THE TAG/PUSHER AXLE TO THE GAWR LABEL RATING OR LOADING THE VEHICLE TO THE GVWR LABEL RATING WILL CAUSE THE PUSHER/TAG AXLE TO BE OVERLOADED.
Remedy: CRANE WILL PROVIDE OWNERS WITH REPLACEMENT VEHICLE CERTIFICATION LABELS AND INSTALLATION INSTRUCTIONS. OWNER NOTIFICATION BEGAN OCTOBER 4, 2002. OWNERS WHO DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CRANE AT 1-918-832-7333.
Additional Info: ALSO, CUSTOMERS CAN CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
NHTSA Source: http://www-odi.nhtsa.dot.gov/recalls/recallresults.cfm?start=1&SearchType=QuickSearch&rcl_ID=02V231000
   
Advertisement

Advertisement

Additional Crane Models

Recalls have also been issued under these model names:

Latest Safety Recalls

Select image for details, including additional styles.

 

Advertisement

Comments

Do you have comments or questions about this recall? Share them here.

Note: The recalling companies may not be monitoring these comments; they should be directed toward the public. Community Guidelines apply.

comments powered by Disqus
Back to Top



Sources may include: National Highway Traffic Safety Administration (NHTSA) and companies involved with this or a related recall.